Influence of substrate hydraulic conductivity on plant water status
The authors of a new study suggest that increasing hydraulic conductivity in the dry range of substrate moisture content occurring during production can increase water availability, reduce irrigation volume, and produce high quality, marketable crops. Three substrates were engineered using screened pine bark (PB) and amending with either Sphagnum peatmoss or coir to have higher unsaturated hydraulic conductivity between water potentials of −100 and −300 hPa.
There was no correlation between substrate unsaturated hydraulic conductivity and saturated hydraulic conductivity (r = 0.04, P = 0.8985). Established Hydrangea arborescens (L.) ‘Annabelle’ plants were grown in the three engineered and a conventional (control) PB substrates exposed to suboptimal irrigation levels (i.e., held at substrate water potentials between −100 and −300 hPa) for 32 days. The plants in the engineered substrates outperformed the control in every growth and morphological metric measured, as well as exhibiting fewer (or no) physiological drought stress indicators (i.e., vigor, growth, plant development, etc.) compared with the control.
The researchers observed increased vigor measures in plants grown in substrates with higher unsaturated hydraulic conductivity, as well as greater plant water uptake. The coir increased unsaturated hydraulic conductivity and provided an increased air space when incorporated into coarse bark vs. if peat was incorporated into bark at the same ratio by volume. Increasing PB hydraulic conductivity, through screening bark or amending bark with fibrous materials, in concert with low irrigations can produce marketable, vigorous crops while reducing water consumed and minimizing water wasted in ornamental container production.
Access the full study at HortScience.